Table of Contents
Advertisement
2-1.
INSTALLATION
Installation of this unit should be performed only by a
qualified service technician.
Model
Volts
BW-200
120
BW-200
230
2-2.
UNPACKING
Sept. 2013
SECTION 2: INSTALLATION
Amps
Watts
5.5
650
550
2.4
The Henny Penny Bun Warmer has been tested, inspected, and
expertly packed to ensure arrival at its destination in the best
possible condition. The cabinet rests on cardboard pads that
sit on a wooden skid. The unit is then packed inside a heavy
cardboard carton with sufficient padding to withstand normal
shipping treatment.
To remove the Henny Penny Bun Warmer from the carton, you
should:
1.
2.
3.
4.
5.
The bun warmer is available from the factory as a 120 VAC unit.
The data plate, located on the rear of the module, will specify
the correct electrical supply. The unit requires a grounded
receptacle with a separate electrical line protected by a fuse or
circuit breaker of the proper rating. If the unit is connected to
electrical supply with a plug and receptacle, the plug must be in
an accessible location, or the unit must be hard wired.
This unit must be adequately and safely grounded.
Refer to local electrical codes for correct grounding
procedures. If fryer is not adequately grounded,
electrical shock could result.
Do not puncture the unit with any objects such as
drills or screws as electrical shock or component
damage could result.
Any shipping damage should be noted in the presence
of the delivery agent and signed prior to his or her
Carefully cut banding straps.
Lift the carton off the unit.
Lift the unit off the cardboard padding and skid.
Peel off any protective covering from the exterior of the cabinet.
The unit is now ready for location and set up.
3
departure.
Advertisement
Table of Contents
