Table of Contents
Advertisement
4-1.
SPECIAL
PROGRAMMING
Sept. 2013
SECTION 4: PROGRAMMING
With POWER switch off, press and hold both the UP and
1.
DOWN buttons, and then turn the POWER switch on until
"SP"shows on the display. Release the UP and DOWN
buttons, and "
F" or "
o
o
Press the UP or DOWN buttons to toggle from "
2.
or "
C" (Celsius) to "
o
o
3. Press the SET button, and "CAL" shows in the display. Press
and hold TEMP button, and press the UP and DOWN buttons
to match the display with the actual temperature.
4. Press the SET button, and "CPU" shows in the display.
Press and hold TEMP button to view the CPU (control PCB)
temperature.
5. Press the SET button, and "OutPutS" shows in the display.
Press the TEMP button to turn the relays, display and heaters,
OFF and ON.
6. Press the SET button, and "In-" shows in the display. Press
and hold either the UP or DOWN button until "In- SYS"
shows in the display. This programs factory settings back
into the controls.
7. Press the SET button. If "C=y" shows in the display, the
time of day shows in the display during normal operation.
If "C=n" shows in the display, "ON" shows in the display
during normal operation. Press the UP and DOWN buttons
to toggle from one to the other.
6
C" shows on the display.
F" (Fahrenheit).
F" to "
C",
o
o
Advertisement
Table of Contents
