Related Manuals for Henny Penny BW-200
Summary of Contents for Henny Penny BW-200
- Page 1 MODEL BW-200 R E G I S T E R W A R R A N T Y O N L I N E AT W W W. H E N N Y P E N N Y. C O M...
-
Page 3: Table Of Contents
TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................1-1 1-1. Safety ....................... 1-1 Section 2. INSTALLATION ...................... 2-1 2-1. Installation ......................2-1 2-2. Unpacking ......................2-1 2-3. Cabinent Dimensions ..................2-2 Section 3. OPERATION ......................3-1 3-1. Operating Components ................... 3-1 3-2. -
Page 4: Introduction
SECTION 1: INTRODUCTION The instructions in this manual have been prepared to aid you in learning the proper procedures for your equipment. Where information is of SAFETY particular importance or is safety related, the words NOTICE, CAUTION, or WARNING are used. Their usage is described below. This appliance is not intended for use by If a problem occurs during the first operation of a new unit, recheck the persons (including children) with reduced... -
Page 5: Installation
2-2. UNPACKING To remove the Henny Penny Bun Warmer from the carton, you should: Carefully cut banding straps. Lift the carton off the unit. Lift the unit off the cardboard padding and skid. -
Page 6: Cabinent Dimensions
2-3. CABINET DIMENSIONS Product Weight (lbs) BW-200 BW-200 Front/Back BW-200 Side Jan. 2014... -
Page 7: Operation
SECTION 3: OPERATION Turn power switch to the ON position. 3-1. OPERATING After a sequence of codes the display shows the time of day, or “ON”. COMPONENTS Press and hold the TEMP button to view the actual temperature of the unit. Due to the lower temperature settings, this unit has been designed to hold NON-POTENTIALLY HAZARDOUS FOOD ONLY. -
Page 8: Programming
SECTION 4: PROGRAMMING With POWER switch off, press and hold both the UP and 4-1. DOWN buttons, and then turn the POWER switch on until SPECIAL “SP”shows on the display. Release the UP and DOWN PROGRAMMING buttons, and “ F” or “ C”... -
Page 9: Troubleshooting
SECTION 5: TROUBLESHOOTING 5-1. ERROR CODES DISPLAY CAUSE PANEL BOARD CORRECTION Turn POWER switch to OFF then back ON; if display still shows “E-4”, the unit is overheating or “ Control board overheating E-4” louvers are clogged Faulty temperature temperature “E-6”... - Page 10 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax www.hennypenny.com *FM05-092-A* Henny Penny Corp., Eaton, Ohio 45320, Revised 10-09-13...