Technical Data; Electrical Connection; Dimensions; Milling Capacity / Removal - Optimum OPTIMILL MF 2V Operating Manual

2

Technical data

The following information gives the dimensions and weight and is the manufacturer's
authorised machine data.
2.1

Electrical connection

Total connection rate
Degree of protection
2.2

Dimensions

Taper
Spindle sleeve diameter
Clamping surface of cross table
Max. dist. from spindle head to table
Max. dist. from centre of spindle to upright
Min. dist. from centre of spindle to upright
Height
Width
Depth
Total weight
Max. load of cross table
Number of the T-slots
Size of the slot nut
Throat depth
2.3

Milling capacity / removal

End-milling cutter ø18
Face milling cutter ø76
2.4

Adjustment travels / swiveling range

Spindle sleeve travel
Adjustment travel of cross table (X-axis)
Adjustment travel of cross table (Y-axis)
Vertical adjustment travel of cross table
Swivel range spindle head carrier
Up/down spindle head inclination
Version 1.3.0 dated 2016-12-16
3 x 400 V; 50 Hz; 1.5 KW
IP 54
ISO 40 (DIN 2080, DIN 69871)
Ø 85.7 mm
230 x 1244 mm
446 mm
680 mm
200 mm
2150 mm
1400 mm
1450 mm
900 kg
230 kg
3
16 x 63 mm
213 - 533 mm
MF2 Vario
6 mm
2.5 mm
127 mm
800 mm
305 mm
406 mm
± 90°
± 45°
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
MF2 Vario GB
Page 17