Basic Maintenance Schedule - Mitsubishi Engine - Generac Power Systems MLT4060M Operating Manual

Light tower
Hide thumbs Also See for MLT4060M:
Table of Contents

Advertisement

Maintenance
overflow jug.
Check the oil level daily. Refer to the engine operator's manual for the proper viscosity grade of oil, including
special operating conditions such as a change in season or climate.
DO NOT start the unit if the engine oil level is below the add mark on the dipstick.
Normal operating level is in the cross-hatch pattern between the full and add markings on the dipstick.
Add oil only if the oil level is below the add mark on the bottom of the cross-hatch pattern on the dipstick.
DO NOT OVERFILL the crankcase.
Check the fuel level.
Note: If the engine was run out of fuel or the fuel tank was drained, it may be necessary to bleed the fuel lines. Refer
to the engine operator's manual supplied with the unit.

BASIC MAINTENANCE SCHEDULE - MITSUBISHI ENGINE

Refer to the original equipment manufacturer's operating manual for a complete list of
maintenance requirements. Failure to comply with the procedures as described in the engine
operator's manual will nullify the warranty, decrease performance and cause equipment
damage or premature equipment failure. Maintenance records may be required to complete
Use the schedule in the following table as a guide for regular maintenance intervals. For additional or replacement
copies of the engine operator's manual, contact an authorized dealer in your area.
Item
Check Oil Level
Check Coolant Level
Check Fuel Level
Check Tire Pressure
Check All Electrical Connections
Inspect Radiator Fins For Debris, Clean As
Required
Inspect Light Tower Winch For Proper Operation
Fuel Tank - Drain Water
Check Air Cleaner
Replace Engine Oil And Oil Filter
Belt And Belt Tension - Inspect And Adjust
Replace Fuel Filter
Drain And Clean Fuel Tank
Check Glow Plugs
Lubricate Leveling Jacks
Bolts And Nuts On The Engine - Retighten
Replace Heated Fuel Filter (If Equipped)
Inspect Engine Starting Battery
Air Cleaner Element - Clean, Check And Replace
Fuel System - Bleed Air
Water Sedimenter - Drain Water
*
Perform after the initial 50 hours of operation, then on the regularly scheduled interval indicated in the schedule
above.
**
Certain conditions may require the fuel tank to be drained and cleaned more often. When operating in extremely
28
a warranty request.
50
Daily
Hours
MLT4060-80M/K Operating Manual
250
400
500
Hours
Hours
Hours
Hours
*
**
1000
As
Required
*
10454 O

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mlt4060kMlt4080mMlt4080k

Table of Contents