Connecting The Blocks; Downloading The Schedule - rotork Mk3 Technical Manual

7.2

Connecting the blocks

The function blocks used to
execute the control strategy
must be connected. The
interconnection of the blocks
requires the use of a
suitable Configuration tool.
All the blocks in the FF CP
card are already instantiated
and ready for use. The
mode for control actions
using the AO or DO blocks
must be set in the
transducer block.
Fig 7.4: Interconnecting blocks to form a control scheme using a 'wiring tool'
7.3

Downloading the schedule

When downloading a schedule
it is essential that any
previously downloaded
schedule is cleared. Failure to
do this may result in the FF
card not functioning as
expected.
Fig 7.5: When downloading a new schedule ensure any previously loaded schedules are
cleared
Publication PUB089-005-00_0618
Setting Up The FF CP Card
75 of 116