Cleaning The Sensors - Microplex logiJET TC8 Operator's Manual

162 Operator Maintenance
__________________________________________________________________________________________

8.1.4. Cleaning the Sensors

_________________________________________________________________________________________
Microplex
The device is provided with sensors to enable controlling of
consumable movements.
The upper media sensor (Transparent sensor) and the lower media
sensor (Reflex sensor) are both
mounting:
During the print process this two sensors first of all may be soiled
by paper dust. A large amount of dirt is able to cause problems.
Go on like this to remove dust and dirt from the sensors:
1. Switch the printer OFF.
2.
3. Unlock the rear printhead assembly by pushing the printhead
release lever and raise the printhead assembly to a vertical
position.
4. Unlock the transparent sensor guide by pushing its lever and
raise the transparent sensor guide until it stops (as shown in
figure 8.1.4.a+b).
logiJET TC8 Edition 1.2