Adjusting The Tear Off Position (Option: Cutting Position) - Microplex logiJET TC8 Operator's Manual

144 Panel Functions
_________________________________________________________________________________________

7.31. Adjusting the Tear Off Position (Option: Cutting Position)

The tear off position is identical to the detected gap position, i.e. with the
perforation or the start of the label. With this function a fine setting of the tear off
position is carried out. The setting range for the offset is approximately +- 10.7 mm.
 If a cutter is installed and activated, the concerning panel function Cutting Position has to be used.
_________________________________________________________________________________________
Microplex
Panel display
[ON LINE ]
[Menu Level 1 ]
  
[Engine ]
[Printspeed ]
  
[TearOff Menu ]
[TearOff Mode ]
  
[TearOff Pos. ]
[Position: - 2.0 mm ]
  
[Position: - 2.5 mm ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[TearOff Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[TearOff Pos. ] is displayed.
The currently set value is displayed.
Press the NEXT or PREVIOUS key until
the desired offset is displayed.
The tear off position is shifted 0.5 mm
(additionally) in feed direction.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ON LINE key
longer than 2 seconds.
logiJET TC8 Edition 1.2