Cleaning The Sensors - Microplex LOGIJET TC8 Operator's Manual

144 Operator Maintenance
_______________________________________________________________________________________________

8.1.4. Cleaning the Sensors

_______________________________________________________________________________________________
MICROPLEX
The device is provided with sensors to enable controlling of
consumable movements.
The upper media sensor (Transparent sensor) and the lower media
sensor (Reflex sensor) are both located "below" the rear printhead
mounting:
During the print process this two sensors first of all may be soiled
by paper dust. A large amount of dirt is able to cause problems.
Go on like this to remove dust and dirt from the sensors:
1. Switch the printer OFF.
2. Open the printer's top cover and swivel it to a vertical position.
3. Unlock the rear printhead assembly by pushing the
printhead release lever and raise the printhead assembly to a
vertical position.
4. Unlock the transparent sensor guide by pushing its lever and raise
the transparent sensor guide until it stops (as shown in figure
8.1.4.a+b).
Operator's Manual LOGIJET TC8 Edition 1.1