Printhead Pressure Adjusting - Microplex logiJET TC8 Operator's Manual

_________________________________________________________________________________________

5.3. Printhead Pressure Adjusting



_________________________________________________________________________________________
Microplex
A correction of the pressure value of both prindheads is necessary,
if the thickness of the new printmedia is bigger or smaller than the
previous one.
In addition the pressure value can be modified in order to adapt the
pressure value, for example, can improve the transfer of the image
from the corresponding ribbon to the printmedia.
Fig. 5.3.a Principle view of the print process
While printing narrow media the printhead may come in contact with
This may lead to an accelerated abrasion of the printhead and to a
Please always do the printhead pressure adjusting for both
printheads (front and rear print unit).
The pressure values of the two printheads should not differ very much.
The operation steps to adjust the pressure value are described on the
following pages.
Handling of Consumables
logiJET TC8
63
Edition 1.2