Pin Mux Tool; Xds110 Driver Installation - Texas Instruments CC3220 Getting Started Manual

www.ti.com
5. Configure the setting as shown in
1.5

Pin Mux Tool

TI recommends installing the
application. This tool helps to configure the pin mux setting for your application. All the provided sample
applications already contain the required pin mux file (output of this tool). The latest version of this tool
can be downloaded from http://www.ti.com/tool/PINMUXTOOL. For more information on this tool, see
http://processors.wiki.ti.com/index.php/TI_PinMux_Tool_v4.
For older versions of this tool, the CC3220 device may not be listed explicitly under the supported devices.
If that is the case, choose the CC3200 device from the drop-down menu to generate the same output files
required by the CC3220 device.
1.6

XDS110 Driver Installation

XDS110 drivers must be installed before one can use the debugger or the Image Creator tool. It also
enumerates the serial terminal port, which can be used to print the debug messages over UART. The XDS
drivers can be obtained from the
http://processors.wiki.ti.com/index.php/XDS_Emulation_Software_Package#XDS110_Reset_Download.
Do the following steps for the installation.
1. Run the installer in administrator mode and click Next, as shown in
SWRU461B – February 2017 – Revised June 2018
Submit Documentation Feedback
Figure 1-6. Click OK to continue.
Figure 1-6. Configure Settings
Pin Mux Tool, although it is not required to get started with your sample
Copyright © 2017–2018, Texas Instruments Incorporated
Pin Mux Tool
Figure 1-7.
Download and Installation
7