Serial Terminal - Texas Instruments CC3220 Getting Started Manual

Serial Terminal

1.4 Serial Terminal
Many sample applications come with UART support for printing the debug information or the status of any
operation. Some applications require user's input through UART, so it is advised to install a serial terminal
application. Tera Term is used for demonstration here.
1. Download Tera Term and install as described in the instructions.
2. Run the Tera Term application.
3. Select the Serial Port, then COM11: XDS110 Class Application/User UART (COM11), as shown in
Figure 1-4. Click OK to continue.
NOTE: Install the XDS110 drivers for the PC to enumerate these ports for serial terminal. See
Section 1.6
4. Go to Setup → Serial port, as shown in
6
Download and Installation
for installation of the XDS110 drivers.
Figure 1-4. Select Serial Port
Figure
Figure 1-5. Set up Serial Port
Copyright © 2017–2018, Texas Instruments Incorporated
1-5.
SWRU461B – February 2017 – Revised June 2018
www.ti.com
Submit Documentation Feedback