Huawei SUN2000-30KTL-US User Manual page 39

SUN2000-(25KTL, 30KTL)-US
User Manual
An expansion bolt contains four parts, as shown in
Figure 4-12 Expansion bolt composition
(1) Expansion sleeve
Figure 4-13 Drilling a hole and installing an expansion bolt

To prevent dust inhalation or contact with eyes, wear safety goggles and an anti-dust
respirator when drilling holes.

Vacuum any dust in or around the holes using a vacuum cleaner and measure the hole
distance. If the holes are inaccurately positioned, drill holes again.

Level the top of the expansion sleeve with the concrete wall after removing the bolt, spring
washer, and flat washer. Otherwise, the rear panel will not be securely installed on the
wall.
1.
2.
3.
Step 3 Align the rear panel with the holes, insert expansion bolts into the holes through the real panel,
and tighten the expansion bolts to a torque of 45 N· m using a torque wrench with an 18 mm
(0.71 in.) open end, as shown in
Issue Draft C (2016-01-12)
Drill a hole in a marked position to a depth of 52–60 mm (2.05–2.36 in.) using a hammer
drill with a Ф16 mm (Φ0.63 in.) bit.
Partially tighten an expansion bolt, vertically insert it into the hole, and knock the
expansion bolt completely into the hole using a rubber mallet.
Remove the bolt, spring washer, and flat washer by rotating them counterclockwise.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
(2) Flat washer (3) Spring washer
Figure 4-14.
4 Installation
4-12.
(4) Bolt
33