Printing and Cutting Positions
Manual-cutter position
Autocutter blade position
Center of the print dotline
The values above may vary slightly as a result of paper slack or variations in the paper.
Take this into account when setting the cutting position of the autocutter.
Partial cuts (a portion of the left edge remains) can be made only on receipt paper with-
out black marks or full-surface label paper without black marks.
When making a partial cut (leaving a portion of the left edge), do not perform a back
feed.
Lengths of receipts/labels
To prevent paper jams or to make it easier to remove printed receipts/labels, the following
lengths are recommended for printing receipts/labels.
Use condition
Horizontal installation (full cut)
Horizontal installation (partial cut)
Vertical installation
Chapter 1 Product Overview
Approx. 14
Approx. 29
Paper feed direction
Recommended issuing length
37.5 mm or more
25.4 mm or more
1
47