Epson TM-L90-i Technical Reference Manual page 36

Die-cut label paper/
Continuous label paper
*: Paper for high-speed printing. Depending on the memory switch (customized values) settings, this paper can
allow printing at the printer's maximum printing speed (Level 9: approximately 150mm/s).
 Paper must not be pasted to the paper roll spool.
 If a manual cutter is used to cut paper with a thickness of 100μm or greater, the paper
 Using roll paper with an inside diameter of 25.4 mm {1"} or less may decrease the detec-
 To ensure high printing quality and performance, it is recommended that you make
36
 HD-75* (Nippon Paper Industries Co., Ltd.)
 HW76B* (Nippon Paper Industries Co., Ltd.)
 HW76C* (Nippon Paper Industries Co., Ltd.
 KL470* (NAKAGAWA MFG(USA).Inc.)
 KL80GT* (NAKAGAWA MFG (Germany). GmbH.)
 150HA* (Ricoh Co., Ltd.)
will slide out of position easily. Take special care when cutting the paper.
tion accuracy of the roll paper near-end sensor.
changes to the printing density settings
the roll paper that is used.
("Customized value" on page 97) according to