Sampling Processing/Average Processing Specification - Mitsubishi AJ65SBT2B-64AD User Manual

3
SPECIFICATIONS
3.4.3
The conversion method can be specified from sampling processing/count average/time
average/moving average for each channel in AJ65SBT2B-64AD.
Specify the conversion method with the lower 8 bit in the CH
(RWwm to RWwm+3). Then, in the specified conversion method, set the count average/
time average/moving average with the upper 8 bit.
After the setting is completed, turn Initial data setting request flag (RY(n+1)9) from off to on
to reflect the setting contents.
The default average processing is the sampling processing (0000
CH Average processing
setting (RWwm to RWwm+3)
Count average/time average/moving average setting
Sampling
processing
Count average
Time average
Moving average
3
- 11 3.4 Functions

3.4.3 Sampling processing/average processing specification

Sampling processing/average processing specification
b15 to
Conversion
method
00 (fixed)
H
04 to FF
H H
00 to FF
H H
00 (4 times), 01
H
02 (16 times), 03
H
04 (64 times), 05
H
* 1 If the sampling processing is set for the channel where the value is set, the value is ignored.
* 2 When setting the value of 04
In this case, the conversion method previously set is applicable to the operation.
Figure 3.4 Sampling processing/average processing specification
b8 b7
*1
Setting range
(4 to 255 times)
((0 to 255) × 0.1ms)
(8 times),
H
(32 times),
H
(128 times)
H
or higher, Error flag (RX(n+1)A) turns on.
H
Average processing setting
).
H
to
Conversion method setting
Setting
Conversion method
value
00
Sampling processing
H
01
Count average
H
02
Time average
H
03
Moving average
H
b0
*2