Mitsubishi AJ65SBT2B-64AD User Manual page 74

5
PROGRAMMING
(2) Program example
Network parameter setting
Starting data link
Remote input signal
Checking the connection status of the AJ65SBT2B-64AD
Figure 5.19 Program example (when using the ACPU/QCPU (A mode) (FROM/TO instructions)) 1/3
5
- 22 5.7 Program Example When Using the ACPU/QCPU (A mode) (FROM/TO Instructions)
Number of connected modules: 1
Number of retries
Number of automatic return modules: 1
Writes parameter settings to the master
station
Data link status when an error
occurs on the CPU module of the master
station: Continue
Writes parameter settings to the master
station
Station information of the
AJ65SBT2B-64AD (remote device station,
occupying 1 station, station No.1)
Writes parameter settings to the master
station
Refresh instruction
Turns on Request for data link start by
parameters in buffer memory (Y06)
Turns off Request for data link start by
parameters in buffer memory (Y06) when
the data link start was completed
Reads the parameter status when the data
link start failed
Turns off Request for data link start by
parameters in buffer memory (Y06) when
the data link start was completed
Reads devices RX00 to RX1F to devices
X100 to X11F
Reads the data link status
Turns on MC contact (M100) when the data
link is normal
Turns on Y60 when a data link error occurs