Description - Biomark IS1001 User Manual

Description

Description
The IS1001 BLE (Bluetooth Low Energy) Data Logger is a data storing accessory device intended
for use with IS1001, RM310 or FS1001A readers. The BLE Data Logger stores tag IDs and
diagnostics data it receives from the attached reader to its internal flash memory.
The BLE Data Logger incorporates a Real Time Clock and uses it to assign time/date stamp to
each tag ID it receives and stores. The incorporated capacitor keeps the clock powered when the
logger's power is off. The BLE Data Logger also stores short versions of the attached IS1001 or
FS1001A reader status reports (status reports are not available for an RM310 reader).
The BLE Data Logger can store up to 1,024,000 tag IDs (with signal level and temperature
measurements, when applicable) and 55,296 status reports. The data is written into memory in
First-In-First-Out (FIFO) manner: if the memory becomes full, the block of oldest records is erased
to make room for the new ones.
The BLE Data Logger also has an option to transmit received tag IDs in real-time via its
communication ports. The logger offers two ways of communication with a PC:
•
Wired connection: RS-232 serial interface.
•
Wireless connection: Bluetooth interface.
The BLE Data Logger's stored data can be downloaded via either of the communication ports.
These communication ports can also be used to establish a direct connection with the attached
reader to configure it or to update its firmware.
Data Logger
Bluetooth
Status LED
Module
•
Data Logger Status LEDs: indicate status of the BLE Data Logger:
o Green "POWER" LED: indicates that power has been applied to the BLE Data Logger.
o Yellow "MODE" LED: indicates bootloader mode code or error code:
▪ Flashing once – bootloader has been entered for firmware update using BioTerm.
▪ Flashing twice – bootloader has not found a valid firmware, waiting for re-
programming via RS-232 port.
▪ Flashing three times – bootloader has detected firmware checksum error, waiting
for re-programming via RS-232 port.
1
Bluetooth
RS-232
Status LEDs
Port
IS1001 BLE Data Logger User Manual
Serial IS1001 IS1001
Number Beeper Status LEDs