Biomark IS1001 User Manual page 14

Commands
LTS {HH:MM:SS}
RDP
Memory
MED
MEE
MSD
MTD
MVT {1|0}
11
Note: The command is only active when Attached Reader
Type is set to RM310.
Set Logger Time (24-hour)
Sets the logger's real-time clock present time. The time is
specified as hh:mm:ss (hours:minutes:seconds) in 24-hour
format.
Note: When data logger's Date/Time settings are updated
using "LDS"/"LTS" commands, Date/Time settings of the
attached IS1001 reader get updated automatically also.
Reset to Factory Default Parameters
Replaces all BLE Data Logger present settings with the
manufacturer default values.
Note: Attached Reader Type present value will be preserved
and will not be changed to default.
Download Entire Memory
Initiates the download of all data contained in the logger's
memory.
The Esc key can be used to cancel the process.
Note: The data will be sent only to the port from which the
memory download was requested.
Erase Entire Memory
Permanently erases all data contained in the logger's memory.
The recommendation is to download the contents of memory
to another computer or storage device before erasing memory.
Download Status Reports Memory
Initiates the download of status reports data contained in the
logger's memory.
The Esc key can be used to cancel the process.
Note: The data will be sent only to the port from which the
memory download was requested.
Note: Status reports are not available for RM310 reader.
Download Tags Memory
Initiates the download of tags data contained in the logger's
memory.
The Esc key can be used to cancel the process.
Note: The data will be sent only to the port from which the
memory download was requested.
Store Virtual Test Tags To Memory {1} On, {0} Off
IS1001 BLE Data Logger User Manual