Biomark IS1001 User Manual page 15

Reader
RAT {1-3}
RIT {0, 10-3600}
Reports
RFS
RSD {0-1440}
IS1001 BLE Data Logger User Manual
Specifies if VTT IDs (3E7.xxxxxxxxxx/999.xxxxxxxxxxxx) will
be stored in the logger's memory as they are received from
IS1001 or FS1001A reader. Valid values are On or Off. Default
is On.
Set Attached Reader Type {1} IS1001, {2} RM310, {3}
FS1001A
Sets attached reader type: RAT1 - IS1001, RAT2 - RM310,
RAT3 - FS1001A. Default is 1 (IS1001).
Set RM310 Reader Idling Time {0} Disabled, {10 - 3600}
Seconds
Enables switching RM310 reader into Read Mode periodically,
according to the selected time interval. Valid values are 0
(disabled), 10 – 3600 seconds. Default is 0 (disabled).
Note: RM310's Read Mode parameter must be set to
Requested (I0020 command), so the reader returns to
Standby mode after one scan cycle. This command is only
applicable with RM310 firmware v3.36 and v3.49.
Note: The command is only active when Attached Reader
Type is set to RM310.
Report Logger Status
Used to generate the logger's status report.
Set Automatic Reader Status Report Request Delay in Minutes
Enables requesting status report periodically from the attached
reader that does not have automatic status report sending
functionality, specifically FS1001A. Default is 0 (disabled).
Note: This command will work with IS1001 but will be
redundant since IS1001 has automatic status report sending
functionality. RM310 does not provide status report, so the
command is not applicable to this reader.
Commands
12