Siemens SIMATIC PN/J1939 LINK Operating Instructions Manual page 36

Mounting/Extending
6.1 Installing the device
Mounting to a control panel
Proceed as follows:
1. Drill holes (M4). The dimensions for the drill holes are available in the figure below.
2. Move the sliders
3. Fasten the module with a cylinder head screw M4 as well as a spring lock washer and a
flat washer.
Note
Do not use a countersunk head screw.
The type of screw required depends on the type of material on which the module is
mounted. Fasten the screw with the corresponding torque until the spring lock washer is
pressed flat.
Do not fasten the screws with excessive torque.
Figure 6-2
34
①
to the outside until they latch in place.
Control panel mounting of the PN/J1939 LINK
SIMATIC PN/J1939 LINK
Operating Instructions, 12/2018, A5E45307564-AA