Miele KM 6629 Operating And Installation Instructions page 55

Problem
The food in the pan
hardly heats up or does
not heat up at all when
the Auto heat-up
function is switched on.
A noise can be heard
after the appliance is
switched off.
 flashes alternately
with  in the timer
display and a tone is
sounding.
1 and a number, e.g. 1-0
flash alternately with a 3
digit number in the
timer display.
 will flash alternately
with numbers in the
timer display.
Possible cause and remedy
There is too much food in the pan.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pan which is better able to conduct
heat.
The fan will continue running until the cooktop has
cooled down. It will then switch itself off
automatically.
The cooktop is incorrectly connected.
 Disconnect the cooktop from the mains electricity
supply.
 Contact Miele. The cooktop must be connected to
the mains according to the wiring diagram.
Cooking zone fault
 Interrupt the power supply to the cooktop for
approx. 1 minute.
 If the problem persists after power is restored,
please contact Miele.

The overheating protection mechanism has been
activated.
 See "Safety features - Overheating protection".
,  or 
The fan is blocked or defective.
 Make sure it has not been blocked by something
like a fork. Remove the cause of the blockage.
 If this fault code continues to appear in the
display, contact Miele.
 and other numbers
There is a fault in the electronic module.
 Interrupt the power supply to the cooktop for
approx. 1 minute.
 If the problem persists after power is restored,
please contact Miele.
Problem solving guide
55