SolarEdge EV Series Installation Manual page 66

RJ45 Pin #
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
7. Use a pre-crimped cable to connect via gland #1 to the RJ45 plug on the inverter's
communication board or, if using a spool of cable, connect as follows:
a. Insert the cable through the gland.
b. Remove the cable's external insulation using a crimping tool or cable cutter and
expose eight wires.
c. Insert the eight wires into an RJ45 connector, as described in Figure 25
d. Use a crimping tool to crimp the connector.
e. Connect the Ethernet connector to the RJ45 port on the communication board.
(1) The inverter connection does not support RX/TX polarity change. Supporting crossover Ethernet cables
depends on the switch capabilities.
EV Charging Single Phase Inverter Guide MAN-01-00588-1.1
Chapter 5: Setting Up Communication to the Monitoring Platform
(1)
Wire Color
T568B
White/Orange
White/Brown
Figure 25: Standard cable wiring
Figure 26: The RJ45 Ethernet connection
T568A
Blue
White/Blue
Orange
Brown
65
10Base-T Signal
100Base-TX Signal
Receive+
Reserved
Reserved
Received-
Reserved
Reserved