34
Opening Conduit Drill Guides
To open conduit drill guides:
1. Move the Connection Unit with Safety Switch ON/OFF/P switch and the inverter
ON/OFF/P switch to OFF.
2. Loosen the screws on the front cover of the Connection Unit with Safety Switch, as
shown below:
Figure 13: Opening the Connection Unit with Safety Switch cover
3. Remove the Connection Unit with Safety Switch cover.
4. Open the required AC and DC conduit drill guides according to the conduits used in
the installation: The drill guides are located at the bottom and sides of the
enclosure, each with two sizes: ¾'' and 1''. Open the required drill guides, taking
care not to interfere with any of the internal components. It is recommended to use
a Unibit drill.
EV Charging Single Phase Inverter Guide MAN-01-00588-1.1