Table of Contents
Advertisement
ChapTer 4 - alphaeCall™ 200 hardWare
» serial to usb adapter
The CA-USBSERV10 Serial to USB Adapter allows the ability to connect a 9-pin serial device to an AlphaECall™ 200 Master.
Only one serial connection can be made to each Master. An AEC200PC can be used to connect additional serial
» noTe:
devices to a network.
Serial hardware that can be connected to a Master are:
•
STR Translator (TL333) - used to receive emergency calls by wired call devices and activate dome lights. See "Wired" section
below on page 10 for details.
•
Wireless Network Coordinator (WNC510) - used to receive emergency calls by wireless devices. See "Wireless Hardware"
section on page 18 for details.
•
Pager Transmitter (TX125-ENC) - used to send emergency notifications to Pocket Pagers.
•
Central Station Dialer (CSD502) - used to contact an off site central station/alarm service to automatically let them know an
emergency call has taken place.
•
Relay Boards (RY008AE) - these can be used to tie in other types of notification devices to AlphaECall. When an emergency
call is received you could trigger visual or audible devices like a strobe light, horn, siren, etc.
» Wired sTr hardware
The STR QwikBUS™ is a 2-wire loop that can have a virtually unlimited number of emergency call devices connected to it. Any type
of device that can either make a momentary or latching dry contact closure can be used with the STR QwikBUS™. Example of these
types of contacts are:
•
Momentary - push button, motion sensor, door or window contacts, bed stations
•
Latching - pullcords, smoke detectors, push-button stations
See the wiring diagrams starting on page 13 for specific wiring instructions.
» Typical Wired Call devices and Components
SF117/2A
Wired Non-LED Emergency Pull Cord Station
SF154A
Wired Non-LED Emergency Push Type Station
10
EPS339
Wired LED Emergency Push Type Station
Advertisement
Table of Contents
