Programming User Scales (Bank 01 To 09) - Kelfar Technologies AK4 Pro SE Manual Manual

I. Programming User Scales (Bank 01 to 09):
1. Press
TUNE/SETUP
1.
LED display shows
2.
Select a User Scale "1=C#, 2 =D, 3=D#, 4=E, 5=F, 6=F#, 7=G, 8=G#, 9=A". User 0 is default of
-50 cents and cannot be programmed or edited.
3.
Select a note to detune (C-B).
4.
LED display will show the value of the selected note.
5.
Use the
TRANSPOSE/ADJUST (+) and (-)
of -64 cents to + 64 cents.
6.
Repeat steps 5 and 6 to program more notes.
7.
Press
TUNE/SETUP
Notes:
1. Press
CANCEL/POWER
new user program.
2. Pressing
TUNE/SETUP
3. Pressing the
RESET
zero.
4. During programming operation the
5. During programming operation the
27
AK-4 Pro SE/VERSION 3
www.kelfar.net
Ux x=0-9
buttons to adjust the value of the selected note within the range
to exit and save the User Scale into the AK 2 Pro internal memory.
to cancel the operation and exit the programming mode without saving the
without a note key being pressed will exit the tuning mode.
button without a note key being pressed will reset the selected user scale to
CANCEL/POWER
TUNE/SETUP
Copyright © 2005-19 Kelfar Technologies
LED is lit red.
yellow LED will begin flashing.