Korg Trinity V3 Firmware Version 3 - Kelfar Technologies AK4 Pro SE Manual Manual

KORG TRINITY V3 FIRMWARE VERSION 3

MAKING THE CONNECTIONS
1. Connect the Midi Out of the AK-4 Pro SE to Midi In Korg Trinity
2. Connect the Midi In of the AK-4 Pro SE to Midi Out Korg Trinity
3. Local Control Off (Please follow the instructions bellow on page 4 to avoid any MIDI FEEDBACK
and or stuck notes )
Local Control Off
PROGRAMMING THE UNIVERSAL MODE 5 / (Mono-Legato Micro-Tuning©)
21.
PRESS and HOLD the
Then, while holding down the
22.
LED Display shows
23.
Press the key "A#".
24.
LED Display shows
25.
Select Mode 5 using the "E" key
26.
LED Display shows
27. Select the Incoming / Outputting Midi Channel and set to channel
TRANSPOSE/ADJUST (+) and (-)
28.
Press
TUNE/SETUP
29. LED Display shows the USB MIDI STATUS
A. (+) Enable/Disable Port 1: 0 is OFF, 1 is ON
B. (RESET) Enable/Disable Port 2: 0 is OFF, 1 is ON
It is best to disable the USB PORTS by using the Transpose/Adjust buttons + and Reset
30.
Press the
CANCEL/POWER
The LED Display shows EP or OFF or BC
31.
Use the Transpose buttons to Turn ON/OFF:
AK-4 Pro SE/VERSION 3
www.kelfar.net
Korg Trinity
.
CANCEL/POWER
CANCEL/POWER
P1
P2
Pc
(Primary Channel) for Mode 5
buttons.
to confirm
to confirm
Copyright © 2005-19 Kelfar Technologies
V3
V3
V3
button, PRESS the
TUNE/SETUP
Pxx, P00
if it shows
button.
1
by using the using the
then skip to STEP 10
52