Programming The Universal Mode 4 / 7 (Polyphonic 12 Notes Max) - Kelfar Technologies AK4 Pro SE Manual Manual

G. Programming the Universal Mode 4 / 7 (Polyphonic 12 notes max)
1. PRESS and HOLD the
Then, while holding down the
2.
LED Display shows
3. Press the key "A#".
4.
LED Display shows
5.
Select Mode 4 using the "D#" key or Mode 7 using the "F#" key
6.
Press the
CANCEL/POWER
7.
LED Display shows the USB MIDI STATUS
STEP 10
A. (+) Enable/Disable Port 1: 0 is OFF, 1 is ON
B. (RESET) Enable/Disable Port 2: 0 is OFF, 1 is ON
It is best to disable the USB PORTS by using the Transpose/Adjust buttons + and Reset
8.
Press the
CANCEL/POWER
The LED Display shows EP or OFF or BC
9.
Use the Transpose buttons to Turn ON/OFF:
EP
Expression Pedal is ON - TR (-)
OFF Expression Pedal and Breath Controller are OFF for (MIDI1) - RESET
BC
Breath Controller is ON for Primary (MIDI1) - TR (+)
10.
Press
CANCEL/POWER
The LED Display shows CCn
11.
12.
Press
CANCEL/POWER
The LED Display shows Cxx (xx=00 to 119) or UL (Master Volume) i.e C11
13.
14.
Select the Control Change Number by using the Transpose/Adjust buttons.
15.
Press
CANCEL/POWER
The LED Display shows Cux (x=0 to 8)
16.
17.
Select the Curve by using the Transpose/Adjust buttons.
18.
Press
CANCEL/POWER
Notes:
1. For this Universal Mode 4 to work, connect the AK4 Pro
sequencer/Synthesizer/Keyboard Midi-In and Midi-Out. (see Figures 1 and 2 above)
2. Set Keyboard to Channel 1
3. Your keyboard must support Pitch Bend Midi Data (for Mode 4) or Fine Tuning Midi
Data (for Mode 7).
4. Set Keyboard to Local control Off. (See Figure 1 above)
5. Set Pitch Bend range to 2 Mode 4.
6. You may further adjust the pitch of each note in the octave (C to B) to -64/+63 cents by
programming your own User Scales 01-09. User 00 is set to -50 cents "fixed."
AK-4 Pro SE/VERSION 3
www.kelfar.net
.
CANCEL/POWER
CANCEL/POWER
P1
P2
to confirm
to confirm
to set up the Control Change
to setup the Control Change.
to setup the Curvature by using the Transpose/Adjust buttons.
to Exit programming the Universal Mode
Copyright © 2005-19 Kelfar Technologies
button, PRESS the
TUNE/SETUP
Pxx, P00
if it shows
MIDI IN/OUT
button.
then skip to
to your multitimbral
24