Changing Programming/Selecting The Primary & Secondary Instruments - Kelfar Technologies AK4 Pro SE Manual Manual

C. Changing Programming/Selecting the Primary & Secondary Instruments
PRESS and HOLD the CANCEL/POWER.
Then, while holding down the CANCEL/POWER button, PRESS the TUNE/SETUP button.
Primary Instrument
LED Display shows
Press CANCEL to skip programming the Primary.
LED Display shows
Proceed to programming the Secondary Instrument down below.
The Primary Instrument (MIDI1) will output the initial instrument MIDI DATA retained
in memory prior to enter programming mode. Steps 1 to 9 will be skipped.
1. Press appropriate key to select the Brand of the instrument as shown on Table of Key
Values below.
LED Display shows
2. Press appropriate key to select the specific Model of the instrument.
3. Expression and Breath Controller statues.
The LED Display shows EP or OFF or BC
Use the Transpose buttons to Turn ON/OFF:
EP
Expression Pedal is ON - TR (-)
OFF Expression Pedal and Breath Controller are OFF for (MIDI1) - RESET
BC
Breath Controller is ON for Primary (MIDI1) - TR (+)
4. Press CANCEL to Select the MIDI CHANNELS by using the following buttons: (C to B)
1CH to 12CH, Tune/Setup 13CH, TR (-) 14CH, RESET 15CH, TR (+) 16CH.
The LED Display shows PCH
5. Press Cancel to setup the Control Change
The LED Display shows CCn
6. Press CANCEL to setup the Control Change.
The LED Display shows Cxx (xx=00 to 119) or UL (Master Volume) i.e C11
Select the Control Change Number by using the Transpose/Adjust buttons.
7. Press CANCEL to setup the Curvature by using the Transpose/Adjust buttons.
The LED Display shows Cux (x=0 to 8)
8. Select the Curve by using the Transpose/Adjust buttons.
9. Press CANCEL to Exit programming the Primary Instrument (MIDI1).
AK-4 Pro SE/VERSION 3
www.kelfar.net
P1
S1
P2
Copyright © 2005-19 Kelfar Technologies 10