Brocade Communications Systems SilkWorm 12000 Design, Deployment And Management Manual page 72

6
SilkWorm 12000 Management Interfaces
sw0:admin> ipAddrShow 4
SWITCH0
Ethernet IP Address: 192.168.149.13
Ethernet Subnetmask: 255.255.255.0
Fibre Channel IP Address: 10.1.1.10
Fibre Channel Subnetmask: 255.255.255.0
SWITCH1
Ethernet IP Address: 192.168.149.14
Ethernet Subnetmask: 255.255.255.0
Fibre Channel IP Address: 10.1.1.11
Fibre Channel Subnetmask: 255.255.255.0
CP0
Ethernet IP Address: 192.168.149.11
Ethernet Subnetmask: 255.255.255.0
HostName : cp0
Gateway Address: 192.168.149.1
CP1
Ethernet IP Address: 192.168.149.12
Ethernet Subnetmask: 255.255.255.0
HostName : cp1
Gateway Address: 192.168.149.1
Backplane IP address of CP0 : 10.0.0.5
Backplane IP address of CP1 : 10.0.0.6
Figure 6-4
Note:
myid: Displays the status of the system and the current session information. Figure 6-5 displays the
output of myid as run from being logged into logical switch 0.
SW0:admin> myid
Figure 6-5
nsShow: Displays the entries in the Name Server. Please note that the area portion of the 24-bit address
is now used. In Figure 6-6, the digit that is in bold and circled is the logical area number. So in this
example, this digit represents logical slot 1. Logical Slot 1 is equivalent to Physical Slot 2. Reference
SilkWorm 12000 Based SAN Designs on page 3-1
address into a physical port number.
6-4
Displaying IP Addresses on a SilkWorm 12000
All Ethernet IP addresses must be on the same subnet. Also be aware that super-netting is not
supported. The range of IP addresses 10.0.0.0 - 10.0.0.254 are reserved for the internal Ethernet
of the SilkWorm 12000.
Current Switch: SW0
Session Detail: SW0 (192.168.149.13) Active
Displaying the current session information on a SilkWorm 12000
Redundant
for further detail in decoding the Fibre Channel 24-bit
Publication Number 53-0000251-02