Cp Card Installation - Brocade Communications Systems SilkWorm 12000 Design, Deployment And Management Manual

7
Maintaining the SilkWorm 12000

CP Card Installation

1. Install the new CP Card or filler panel in the slot.
Caution:
a.
b.
c.
If a filler panel was installed, the installation procedure is now complete.
2. Additional steps if a CP Card was installed:
a.
7-16
Do not force the installation. If the CP Card or filler panel does not slide in easily, ensure
it is correctly oriented and aligned in the rail guides before continuing. Installing a CP Card
or filler panel with incorrect alignment damages the chassis and the CP Card or filler panel.
Orient the CP Card or filler panel so that the ejectors are at the front of the switch and the flat
metal side is on the left.
Align the flat metal side of the CP Card or filler panel inside the upper and lower rail guides in
the slot, and slide the CP Card or filler panel into the slot until it is firmly seated.
Close the ejectors by pushing the black handles in toward the CP Card or filler panel, until the
handles click.
The levering action of the handles seats the CP Card or filler panel in the switch.
Verify that the CP Card Power LED on the CP Card is displaying a steady green light.
If not, ensure the CP Card has power and is firmly seated. The front of the CP Card should be
flush with the adjacent cards or filler panels, with both ejectors closed.
Note:
The LEDs patterns may temporarily change during POST and other diagnostic tests.
Publication Number 53-0000251-02