Paper Dispenser - biodex ECONO Operation Manual

Paper Dispenser (058-611)

Manufactured to accommodate a roll of hygienic table paper (sold separately,) the optional paper
dispenser is mounted to the head end of the table.
Installing the paper dispenser:
1. Raise the Fowler back section of the table completely.
2. Using a 7/16" wrench, remove the two 1/4-20" hex head screws from under one side of the
head end of the Fowler back cushion. (See Figure 10.)
3. Position the appropriate paper dispenser mounting bracket on the bottom of the Fowler back
cushion as shown below. Ensure the pre-drilled screw holes align with the screw holes from
step 2.
4. Using a 7/16" wrench, install the two 1/4-20" hex head screws removed in step 1 through the
dispenser mounting bracket and tighten to secure the paper dispenser bracket in place.
5. Repeat steps 1 - 4 for the opposite side.
6. Place a role of paper on the paper dispenser rod and install the rod between the brackets.
Press in on either spring-loaded end of the paper dispenser bar in order to slide it into the
brackets.
7. Pull the paper over the cushions.
8. Pull unused paper through the cutter strap which mounts at the foot end of the table.
9. After use, cut the paper and dispose of used portions.
Mounting Bracket
Mounting Bracket
Figure 10. Using a 7/16" wrench, install the two1/4-20" hex
head screws removed in step 1 through the dispenser
mounting bracket and tighten to secure the paper dispenser
bracket in place. Repeat steps 1 - 4 for the opposite side.
Figure 11. Place a roll of paper on the paper dispenser rod
and install the rod between the brackets. Press in on either
spring-loaded end of the paper dispenser bar in order to
slide it into the brackets.
8