Table of Contents
Advertisement
3
Using the Instrument
Adding the M829xA to the Connection Expert
30
A standard M8290A system is pre-configured at the factory. This section
shows how to modify the factory configuration or to configure a
stand-alone module.
1
Open the Connection Expert by clicking its icon (
tray and selecting the corresponding item from the context menu.
2
Click on the Add (
select LAN instrument from the drop-down list.
3
Go to the 'Enter Address' tab.
4
Enter the hostname or the IP address of the embedded controller
running the M8290A software. Then set the Protocol to HiSlip and
enter the remote name as displayed on the M8290A Software user
interface.
) button in the "My Instruments" section and
Keysight M8290A Getting Started Guide
) in the system
Advertisement
Table of Contents
