Table of Contents INTRODUCTION ......................... 6 Welcome ................................6 Future Products Group (FPG) ........................6 Guidance and Help ............................. 6 Warranty ................................6 Warranty Period ............................6 Liability Exceptions ............................. 7 Specific Exclusions ............................. 7 Assessment ..............................7 Time Limit ..............................7 Caution ...............................
Page 4
Routine................................13 Schedules ..............................13 Inspection ..............................13 Correction ..............................13 INSTALLATION ........................ 14 Regulations ..............................14 Compliance with Local Requirements ...................... 14 Setting Up ............................... 14 Unpacking ..............................14 Site Preparation ............................14 Cabinet Preparation..........................14 Tilt Door Adjustment ..........................14 Location ................................
Page 5
ELECTRICAL CIRCUIT DIAGRAMS ................20 Model: IN 5A08 ............................20 Model: IN 5A12 ............................20 Model: IN 5A15 ............................21 Model: IN 5A18 ............................21 SPARE PARTS ......................... 22 Cabinet Serial Number ..........................22 Location of Glass Parts ..........................23 MECHANICAL DRAWINGS ....................
INTRODUCTION Welcome AMBIENT CABINETS INTRODUCTION Future Welcome to the world of FPG! Our products are designed and engineered to Products give you the optimal performance that you deserve with innovative visual Group (FPG) merchandising appeal. We are confident that you will be delighted with your state of the art inline food service cabinet, and that it will become a valued appliance in your store.
Fair wear and tear. Assessment The liability under this warranty is dependent on an assessment by FPG, to determine the defect in workmanship or materials. Time Limit FPG does not guarantee that any service to be performed under this warranty will be carried out within any particular time limit.
OPERATION Cabinet Layout AMBIENT CABINETS OPERATION Tilt or Sliding The tilt door cabinet has a single front door and two Front Doors sliding rear doors. The front door is hinged along the bottom edge, and is opened by pulling the top edge forward. When opened, the door is restrained from falling by wire cables, which retract into “pull...
Controls AMBIENT CABINETS OPERATION Control Panel The control panel is mounted on the lower back of the cabinet. The only control is a light switch. Lights To turn the lights on, rotate the light switch in a clockwise direction. To avoid possible damage to the electronic ballasts, fluorescent tubes which flicker or fail to strike must be replaced without delay.
Preparation cont. AMBIENT CABINETS - OPERATION Shelf To move the shelf support Adjustment brackets, remove all the shelves and then remove the rear sliding doors. Using two people, one on each bracket, slide the bracket upwards and disengage it from the support pillar.
TROUBLE SHOOTING FAULT POSSIBLE CAUSE REMEDY Door not in track Install door correctly in track Debris in track Clean door tracks (see cleaning) Doors are not sliding smoothly Door glider damaged/missing Have glider replaced Apply food grade lubricant to Lack of lubricant door track The mains isolating switch on the wall, circuit breaker or...
CLEANING Cautions AMBIENT CABINETS CLEANING Power ALWAYS TURN THE POWER SUPPLY OFF BEFORE CLEANING. Water THIS UNIT IS NOT WATERPROOF. DO NOT USE A WATER JET SPRAY TO CLEAN THE INTERIOR OR EXTERIOR OF THIS CABINET. Exterior AMBIENT CABINETS CLEANING Painted and Painted, stainless steel or aluminium surfaces should be cleaned with hot soapy Metal Surfaces...
Interior AMBIENT CABINETS CLEANING Trays and Stainless steel trays, shelves, grills etc. should be cleaned with hot soapy water. Shelves Do not use abrasive pads or cleaners (e.g. Scotchbrite pads or Jif), as these may damage surfaces. Warning: Dishwasher detergents will damage the anodised aluminium shelves. Tilt Door Glass Gently pull the top of the door forward, until it is restrained in the open position.
INSTALLATION Regulations AMBIENT CABINETS INSTALLATION Compliance It is very important that your inline food cabinet is installed correctly and that the with Local operation is correct before use. Installation must comply with local electrical, Requirements health & safety and hygiene requirements. Setting Up AMBIENT CABINETS INSTALLATION...
Location AMBIENT CABINETS INSTALLATION Ventilation Before use, operate the cabinet for 1-2 hours to remove any fumes or odours, which may be present. Access The cabinet should also be positioned so the operating panel and shelves are easily reachable for loading and unloading. Power Supply AMBIENT CABINETS INSTALLATION...
SERVICING Lighting AMBIENT CABINETS SERVICING Caution DO NOT service lights without isolating the cabinet at the main switch or unplugging it from the wall. Control Gear The control gear, including the LED lighting power Chassis supplies, is located behind the left hand rear panel. All low power circuits are protected by a circuit breaker, MCB, which can be operated via a cut-out in the top of the chassis.
Mains Lead AMBIENT CABINETS SERVICING Lead If damaged, the mains lead must ONLY be replaced by a qualified service Replacement person. Gaskets AMBIENT CABINETS SERVICING Qlon Gaskets On tilt front cabinets, the front door aperture is fitted with a Qlon gasket along the top.
SPECIFICATIONS Mechanical AMBIENT CABINETS SPECIFICATIONS CABINET MODEL IN 5A08 IN 5A12 IN 5A15 IN 5A18 1443 mm 1443 mm 1443 mm 1443 mm Height 807 mm 1207 mm 1507 mm 1807 mm Width 789 mm 789 mm 789 mm 789 mm Depth 108 kg 135 kg...
Number the label fixed to the control panel. This serial number will enable FPG to trace details of the build specification of your particular cabinet, and hence ensure that spare parts are fully compatible. To satisfy warranty conditions, and ensure optimum performance, use only FPG supplied spare parts.
In the following table, handed glass parts are labelled as viewed from the REAR Glass Parts of the cabinet. Part Description FPG Part Number End Glass LH/RH (Except for Butted Glass Cabinets) 21191 End Glass LH (Butted Glass Cabinets) 18887...
Square Glass Cabinets Types IN 5A08/12/15/18 Note: The 1800mm wide cabinet is fitted with four rear doors. Part No. 26109 Rev. C December 2015 - 28 - 5000 Series Cabinets...
Need help?
Do you have a question about the INLINE 5000C Series and is the answer not in the manual?
Questions and answers