Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FPG INLINE 4000S Series
Summary of Contents for FPG INLINE 4000S Series
- Page 1 Heated Cabinets Square Format...
- Page 2 Copyright © September 2018 Future Products Group Limited. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Future Products Group Ltd.
-
Page 3: Table Of Contents
Table of Contents INTRODUCTION ........................ 6 Welcome ................................6 Future Products Group (FPG) ........................6 Guidance and Help ............................ 6 Warranty ................................6 Warranty Period ............................6 Liability Exceptions ............................ 7 Specific Exclusions ............................ 7 Assessment ............................... 7 Time Limit ..............................7 Caution .............................. - Page 4 INSTALLATION ....................... 14 Regulations ..............................14 Compliance with Local Requirements ..................... 14 Setting Up ..............................14 Unpacking ............................... 14 Site Preparation............................14 Cabinet Preparation ..........................14 Shelf Trays .............................. 14 Grounding..............................15 Power Supply ............................15 Isolation ..............................15 Location ................................ 15 Ventilation..............................
- Page 5 ELECTRICAL CIRCUIT DIAGRAMS ................21 Model: IN 4H08S ............................. 21 Model: IN 4H12S ............................. 21 Model: IN 4H15S ............................. 22 SPARE PARTS ........................ 23 Cabinet Serial Number ..........................23 Location of Glass Parts ........................... 24 MECHANICAL DRAWINGS ..................... 25 Dimensions ..............................25 IN-4H08S/12S/15S Square - Sliding front doors ..................
-
Page 6: Introduction
INTRODUCTION Welcome HEATED CABINETS INTRODUCTION Future Welcome to the world of FPG! Our products are designed and engineered to Products give you the optimal performance that you deserve with innovative visual Group (FPG) merchandising appeal. We are confident that you will be delighted with your state of the art inline food service cabinet, and that it will become a valued appliance in your store. -
Page 7: Liability Exceptions
• Fair wear and tear. Assessment The liability under this warranty is dependent on an assessment by FPG, to determine the defect in workmanship or materials. Time Limit FPG does not guarantee that any service to be performed under this warranty will be carried out within any particular time limit. -
Page 8: Operation
OPERATION Cabinet Layout HEATED CABINETS OPERATION 4000 Series The 4000 Series cabinets are available with either fixed glass Cabinets or sliding glass front doors, and sliding glass rear doors. The series includes Ambient, Heated and Refrigerated models. The cabinet lighting and temperature controls are on the back of the cabinet. -
Page 9: Preparation
Preparation HEATED CABINETS OPERATION Shelf Location All shelves are adjustable in height and can easily be and Ticketing moved up or down, to match product size. The movement is restricted to 50mm, because of the electric cables to the lights. For greater movement contact the manufacturer or supplier for advice, as electrical modifications may be required. -
Page 10: Load Cabinet
Preparation cont. HEATED CABINETS - OPERATION Load Cabinet Load the cabinet with pre-heated product. The cabinet is designed to maintain the temperature of pre-heated product above 65C. It is not an oven, and consequently, if cold product is introduced, there could be a considerable delay before the operating temperature rises to the normal operating level. -
Page 11: Trouble Shooting
TROUBLE SHOOTING FAULT POSSIBLE CAUSE REMEDY Door not in track Install door correctly in track Debris in track Clean door tracks (see cleaning) Doors are not sliding smoothly Apply food grade lubricant to Lack of lubricant door track The mains isolating switch on the wall, circuit breaker or Turn isolating switch circuit fuses are off at the power... -
Page 12: Cleaning
CLEANING Cautions HEATED CABINETS CLEANING Power ALWAYS TURN THE POWER SUPPLY OFF BEFORE CLEANING. Water THIS UNIT IS NOT WATERPROOF. DO NOT USE A WATER JET SPRAY TO CLEAN THE INTERIOR OR EXTERIOR OF THIS CABINET. Exterior HEATED CABINETS CLEANING Metal Surfaces Stainless steel or aluminium surfaces should be cleaned with hot soapy water or a good quality metal cleaning compound. -
Page 13: Interior
Interior HEATED CABINETS CLEANING Cabinet Well To clean the hot cabinet well, first lift out the deck trays and dividers and then sweep out or vacuum away loose debris. This cabinet is a dry well unit, so the well is not waterproof. Do NOT pour water into the well as it will leak out and damage insulation and electrical wiring. -
Page 14: Installation
INSTALLATION Regulations HEATED CABINETS INSTALLATION Compliance It is very important that your inline food cabinet is installed correctly and that the with Local operation is correct before use. Installation must comply with local electrical, Requirements health & safety and hygiene requirements. Setting Up HEATED CABINETS INSTALLATION... -
Page 15: Grounding
Setting Up cont. HEATED CABINETS - INSTALLATION Grounding WARNING: THIS APPLIANCE MUST BE GROUNDED TO EARTH The grounding lead, in the mains cable, must always be connected to ground. Terminals are also provided, to allow the cabinet to be bonded to a surge grounding conductor or to adjacent equipment. -
Page 16: Servicing
SERVICING Control Gear HEATED CABINETS SERVICING Location The electrical control gear is located in the top of the cabinet. Remove the top plate to access the switches, LED power supplies, electronic temperature controller and fuse. Lighting HEATED CABINETS SERVICING Caution Do not service lights without isolating the cabinet from the mains supply. -
Page 17: Heating
Heating HEATED CABINETS SERVICING Caution DO NOT attempt to replace heating elements without isolating the cabinet at the supply switch or by unplugging it from the mains supply. Element Remove all base trays and dividers from Replacement inside the cabinet, to reveal the heating elements. -
Page 18: Door Seals
Door Seals HEATED CABINETS SERVICING Seal The doors should be removed to allow the old seals to be removed and the new Replacement ones fitted. See the Cleaning section for details. Sliding Doors Each sliding door has a seal between the door and the cabinet end panel. The seal slides into a groove in the door extrusion, and can be withdrawn and replaced, if damaged. -
Page 19: Specifications
SPECIFICATIONS Mechanical HEATED CABINETS SPECIFICATIONS CABINET MODEL IN 4H08S IN 4H12S IN 4H15S Height 1405 mm 1405 mm 1405 mm Width 803 mm 1203 mm 1503 mm Depth (curved / square) 774 / 778 mm 774 / 778 mm 774 / 778 mm Weight (curved / square) 107 / 135 kg 140 / 170 kg... -
Page 20: Compliance
22°C Ambient with 65% RH Improvements HEATED CABINETS SPECIFICATIONS Ongoing FPG reserves the right to change specifications and construction, as part of Development ongoing product improvement. Part No. 26124 Rev. G September 2018 - 20 - Inline 4000 Series Cabinets... -
Page 21: Electrical Circuit Diagrams
ELECTRICAL CIRCUIT DIAGRAMS Model: IN 4H08S Inline 4000 Series, 800mm Heated Cabinet Model: IN 4H12S Inline 4000 Series, 1200mm Heated Cabinet IN 4H 08S/12S/15S - 21 - © Future Products Group... -
Page 22: Model: In 4H15S
ELECTRICAL CIRCUIT DIAGRAMS, Continued Model: IN 4H15S Inline 4000 Series, 1500mm Heated Cabinet Part No. 26124 Rev. G September 2018 - 22 - Inline 4000 Series Cabinets... -
Page 23: Spare Parts
Number the label fixed to the control panel. This serial number will enable FPG to trace details of the build specification of your particular cabinet, and hence ensure that spare parts are fully compatible. To satisfy warranty conditions, and ensure optimum performance, use only FPG supplied spare parts. -
Page 24: Location Of Glass Parts
Location of In the following table, handed glass parts are labelled as viewed from the REAR Glass Parts of the cabinet. Part Description FPG Part No. 4K Square Glass End Panel LH-RH 21234 4K Square Glass Top DG 800 21249... -
Page 25: Mechanical Drawings
MECHANICAL DRAWINGS Dimensions HEATED CABINETS MECHANICAL DRAWINGS IN-4H08S/12S/15S Square - Sliding front doors IN 4H 08S/12S/15S - 25 - © Future Products Group... -
Page 26: In-4H08S/12S/15S Square - Fixed Front Glass
Dimensions cont. HEATED CABINETS - MECHANICAL DRAWINGS IN-4H08S/12S/15S Square – Fixed front glass Part No. 26124 Rev. G September 2018 - 26 - Inline 4000 Series Cabinets... - Page 27 IN 4H 08S/12S/15S - 27 - © Future Products Group...
- Page 28 Part No. 26124 Rev. G September 2018 For full contact details please visit the Contacts page on FPGWORLD.COM or email us at support@fpgworld.com In line with policy to continually develop and improve its products, Future Products Group reserves the right to change specifications and design without notice. AUSTRALIA CHINA | ASIA EUROPE...
Need help?
Do you have a question about the INLINE 4000S Series and is the answer not in the manual?
Questions and answers