Wshs Removal And Installation Procedure; Removal Via Lead Clipping Methodology; Figure 10. 55-Degree Angle Clippers - Intel 848P Thermal Design Manual

Reference Thermal Solution
4.3.3

WSHS Removal and Installation Procedure

Two methods exist for WSHS removal, lead clipping or de-soldering. Re-installation of the heatsink
for rework or metrology purposes includes a single method.
4.3.3.1

Removal via Lead Clipping Methodology

Recommended Equipment List
• 55-degree angle clippers (Figure 10)
• Solder wicking kit

Figure 10. 55-Degree Angle Clippers

Removal Procedure
1. Remove processor heatsink retention mechanism.
2. Cut the WSHS leads using the 55-degree angle clippers. To reduce potential of damaging board
and components, cut the leads in the order shown in Figure 11.
3. Flip the board over and remove the leads, using tweezers and a soldering iron with a STTC 137
tip.
4. Apply flux and remove any residual solder from each hole.
5. Inspect the board and ensure all holes are clean and completely free of solder. Make sure none
of the adjacent components were damaged during the removal process.
24
®
Intel 848P Chipset Thermal Design Guide
R