Table of Contents
Advertisement
•
The IR Receiver does not work together with some A/V apparatus and models which use
a higher IR frequency like for instance Bang&Olufsen (B&O) .
•
Ensure that the IR Receiver and the IR Extender Cable are correctly connected and that
these are plugged in properly.
•
Please ensure that the LEDs of the IR extender cable are placed correctly to the infrared
sensor of the A/V device, this has to be done very precisely. The exact position can be
found easily by shining at it with a flashlight.
•
Some IR windows from set-top and satellite boxes are very sensitive and are easily
disrupted. These devices then receive too much infrared light and will either work badly
or not work at all. Relocate the IR LED or IR Blaster so that less infrared light is received
via the IR window.
Do you have questions that were not answered in the above mentioned ?
Then look at www.marmitek.com.
5. TECHNICAL DATA
IR Module
Feed POWER:
Feed STATUS:
IR LEDs connections:
IR Receiver connection:
Dimensions:
IR receiver built-on
Frequency range:
IR reception range:
Length of cable:
IR receiver:
IR reception angle:
Dimensions receiver bloc:
IR receiver built-in (optional)
Frequency range:
IR reception range:
Length of cable:
IR receiver:
IR reception angle:
Dimensions receiver:
IR CONTROL 8
TM
100-240VAC 50/60Hz, 12VC 500mA (supplied).
12VDC 200mA. Plug, - 5.5 mm outside / + 2.1 mm
inside (not supplied).
4 x 3.5 mm jack plug (mono).
1 Connector for maximal 3 parallel connected receivers.
85x49x24xmm (fastening points inclusive).
30-60 KHz.
± 10 metres.
4 metres, extendable to max 300 metres (UTP or equivalent).
Reception indication LED.
90° (+45°/-45° from centre).
32x13x12mm.
30-60 KHz.
± 10 metres
2 metres, extendable to max 300 metres (UTP or equivalent).
Reception indication LED.
90°(+45°/-45° from centre)
Diameter 15.9 mm - Drilling size 16 mm - Length 50 mm
Built-in depth 55 mm - Maximal thickness of material 40 mm.
7
Advertisement
Table of Contents
