Frequently Asked Questions; Technical Data - Marmitek Powermid 300 XTRA User Manual

• Some satellite receivers must be placed closer to the Powermid 300 XTRA™ as a result
of the effect the two devices have on one another. Try the Transmitter at a range of
locations in order to obtain the best range.

5. FREQUENTLY ASKED QUESTIONS

• In a few cases, the Receiver may be disrupted by interference and cannot, therefore, pick
up the signals it receives. If this is the case the red light will be continuously illuminated
and the Receiver must be relocated. This interference is caused by equipment in the
vicinity such as dimmers, energy-saving light bulbs, IR alarms and so on. Direct sunlight
can also disrupt the Receiver.
• Powermid 300 XTRA does not work with remote controls which use High Frequency
signals (such as B&O)
Do you have other questions that have not been resolved by the above information?
Please go to www.marmitek.com

6. TECHNICAL DATA

IR Receiver
Power:
RF range:
RF frequency:
IR frequency range:
IR reception angle:
IR reception range:
Dimensions:
IR Transmitter
Power:
IR Output:
IR transmission range:
Dimensions:
Powermid 300 XTRA™
2 x AAA 1.5V non-rechargeable alkaline batteries (included) or
micro USB (not included)
Up to 100m free field, up to 30m through walls and ceilings
433.92 MHz
30 – 60 kHz
60°(+30°/-30° from center)
4 – 8 meters
72 x 67 x 58 mm
100 – 240 VAC 50/60Hz, micro USB adapter (included)
1x 3.5mm jack plug
4 – 8 meters
72 x 67 x 58 mm
5