Frequently Asked Questions; Technical Data - Marmitek Megaview60 User Manual

6. FREQUENTLY ASKED QUESTIONS

Bad (or no) image and sound
• Ensure that the CAT5e/6 cables are connected correctly between the MegaView60
transmitter and receiver (CAT5e-1 to CAT5e-1 and CAT5e-2 to CAT5e-2).
• Check if the A/V device is switched on.
• Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable Requirements).
• Check if the CAT5e/CAT6 cable provides a solid connection (no cable faults).
• Check if the RJ-45 has been connected according to the EIA/TIA T568B standard. Please
refer to attachment page 27
• Please ensure that the maximum cable length is not exceeded.
• Install your system as far away from any RF sources (wireless devices) as possible.
• Set a low resolution on your HDMI source. The CAT5e/6 cable used probably cannot deal
with the higher resolution bandwidth.
Do you have any questions that are not answered above?
Please check www.marmitek.com.

7. TECHNICAL DATA

Resolution
Supported HDTV Resolutions
Single link Bit Rate (max)
MegaView60 transmitter
HDMI input (19-pin female)
Video signal input
DDC signal input
MegaView60 reciever
HDMI output (19-pin female)
Video output
CAT5e/6 cable length (max.)
Transmitter/receiver
Dimensions (H x B x D)
Weight
Environment
Ambient temperature
Ambient humidity
MegaView60™
480p, 576i, 576p, 720p, 1080i, 1080p
1.65 Gbps
1 HDMI
0.5 - 1.0V p-p
5V p-p
1 HDMI
HDMI 1.2a
60m for 480p and 30m for 1080p
45mm x 25mm x 81mm
246g
+0 to +70° C
10% to 85%
5