Energy Saving System; Storage; Installation; Installation - Astoria Tempesta SAEP Use And Maintenance Manual, Instructions For The User

Energy Saving System

3.8
The machine is equipped with software that man-
ages the automatic standby system during breaks, the
night energy-saving feature and the smart temperature
adjustment.
This allows a considerable amount of energy to be
saved during night breaks, whilst maintaining the ma-
chine in a condition that can quickly return to operating
mode.
Moreover, the software only distributes the power
where and when needed, thus allowing energy to also
be saved during normal operation.
When programmed, the system automatically puts
one or more groups into standby mode when the work-
load decreases and prepares them for full capacity when
needed.
Three choices are provided:
• : Stand by manual activation
• : programmed operation
• : self-learning management.
To activate the Energy Saving mode, see para. 7.13 on page 22.
4.

STORAGE

The machine is stored by the Manufacturer or the
Distributor.
5.

INSTALLATION

The machine must only be installed by one of the
Manufacturer's Qualified Technicians.
The machine's support base must be perfectly level and have no
irregularities.
6.

COMMISSIONING

The machine must only be commissioned by one of
the Manufacturer's Qualified Technicians.
16 44
of
7.

OPERATION

Safety precautions

7.1
Carefully read the instructions provided in chapter "1. SAFETY
PRECAUTIONS" on page 3 .

Emissions

7.2

VIBRATIONS

Under conditions of use that meet the indications of
correct use provided in this manual, any detected vibra-
tions do not give rise to dangerous situations.

SOUND EMISSIONS

The noise level emitted by the machine is on average
lower than 70 dB; therefore, there is no obligation to use
personal protective equipment for the auditory system.
Notify the Manufacturer if the machine emits unusual
noises.
ELECTROMAGNETIC ENVIRONMENT
The machine is designed to work properly in any
industrial electromagnetic environment, falling within
the Emission and Immunity limits provided by current
standards.

Turning the machine on and off

7.3
After the hydraulic and electrical mains have been
connected by a Qualified Technician, make sure that the
drain tray under the cup holder grille (10) is correctly
connected to the drain.
10
USER Manual