Ups Startup And Shutdown - Eaton DX RT 6K UPS User Manual

External [0~20]
battery
modules
External [0~300]
battery AH
setting
Battery [enabled] [disabled]
remaining time
Charger [0~4] 0~4A for standard model
current [0~12] 0~12A for long backup model
Site wiring [disabled] [enabled]
fault alarm
LCD contrast [-5 ~ +5]

5.5 UPS startup and shutdown

Please make sure there is no load connected to the ups before the ups is
turned on, and take on the load one by one after the UPS is turned on.
Take off all of the connected loads before turning off the UPS.
Starting the UPS with utility
Verify that the total equipment ratings do not exceed the UPS capacity to
prevent an overload alarm.
Start the UPS with utility:
Check all the connection is correct.
Power on the UPS, the fan begins to rotate. After that, the LCD will show the
default UPS status summary screen.
Pressing button continuously for more than 1 second, the buzzer will beep
300ms, UPS starts to turn on.
A few seconds later, the UPS turns into Line mode. If the utility power is abnormal,
the UPS will transfer to Battery mode without output interruption of the UPS.
Starting the UPS on Battery
According to model
According to model
[enabled]
[1.4A] for 6K
[2A] for 10K
[4A] for 6KS/10KS
[disabled]
[+0]
23