Dentsply Sirona CEREC MC XL Supplement To Operating Instructions page 15

Dentsply Sirona
Supplement to Operating Instructions
62 38 344 D3439
D3439.201.04.04.02 08.2018
Blocks with 6 mm diameter block holders
NOTE
Fasten the block tightly
If the block is not sufficiently tightened, it can lead to unsuitable results
and ceramic breakages.
➢ Securely tighten the block with the block clamping tool with the
torque wrench, until you can hear a clicking sound.
➢ Check to make sure that the block is seated very firmly.
1. Insert the adapter sleeve (A) into the block fixing.
NOTE
Insert the adapter sleeve
The slot at the bottom end of the adapter sleeve must lie above the
radial pin of the block fastener in order to be inserted fully.
The hole for the ball pressure screw is then automatically in the correct
position, i.e. coincides with the threaded hole in the block fixing.
2. Insert the block (B) into the adapter sleeve.
3. Clamp the ceramic block securely with the ball pressure screw (C).
Use the block clamp tool with torque wrench for this purpose.
 The block is pressed laterally against the contact surface of the
block fixing and simultaneously pulled in axially. The plate of the
block holder thus rests on the block fixing.
Removing the adapter sleeve
1. Loosen the ball pressure screw.
2. Place the block clamp tool in the inner groove (D) and pull out the
adapter sleeve.
2 Manual block clamp
5