Parameter List - Mitsubishi 700 Series Instruction Manual

3.6.3

Parameter list

indicates simple mode parameters.
......V/F control
V/F V/F V/F
......General-purpose magnetic flux vector control
GP MFVC GP MFVC GP MFVC
(Parameters without any mark are valid for all control.)
" " indicates enabled and "x" indicates disabled of "parameter copy", "parameter clear", and "all parameter clear".
"∗" indicates a communication parameter which is not cleared by parameter clear (all clear) from RS-485 communication.
(For more information on RS-485 communication,
Parameter
Function
0
Torque boost
Second torque
46
boost
Maximum
1
frequency
Minimum
2
frequency
High speed
maximum
18
frequency
3
Base frequency
Base frequency
19
voltage
Second V/F (base
47
frequency)
Multi-speed setting
4
(high speed)
Multi-speed setting
5
(middle speed)
Multi-speed setting
6
(low speed)
24
Multi-speed setting
to
(4 speed to 7 speed)
27
Multi-speed setting
232
(8 speed to 15
to
239
speed)
Incre- Initial
Name
ments Value
6/4/3/
0.1%
2% ∗
0.1% 9999
0.01Hz 120Hz 0 to 120Hz Upper limit of the output frequency.
0.01Hz 0Hz
0.01Hz 120Hz
0.01Hz 60Hz 0 to 400Hz
0.1V 9999
0.01Hz 9999
0.01Hz 60Hz 0 to 400Hz Frequency when RH turns ON.
0.01Hz 30Hz 0 to 400Hz Frequency when RM turns ON.
0.01Hz 10Hz 0 to 400Hz Frequency when RL turns ON.
0.01Hz 9999
0.01Hz 9999
refer to Chapter 4 of the Instruction Manual (Applied).)
Range Description
Set the output voltage at 0Hz as %.
* Initial value depends on the inverter capacity.
0 to 30%
(0.75K or more/1.5K to 3.7K/5.5K, 7.5K/11K,
15K)
0 to 30% Torque boost when the RT signal is on.
9999 Without second torque boost
0 to 120Hz Lower limit of the output frequency.
120 to Set when performing the operation at
400Hz 120Hz or more.
Rated motor frequency.
(50Hz/60Hz)
0 to 1,000V Base voltage.
95% of power supply voltage
8888 (95% of doubled power supply voltage for
single-phase 100V power input model.)
Same as power supply voltage
(Twice the amount of the power supply
9999
voltage for single-phase 100V power input
model.)
0 to 400Hz Base frequency when the RT signal is ON.
9999 Second V/F invalid
0 to 400Hz
Frequency from 4 speed to 15 speed can
9999
be set according to the combination of the
RH, RM, RL and REX signals.
0 to 400Hz,
9999: not selected
9999
Parameter list
75
3