Operation Lock (Press [Mode] For A While (2S)) - Mitsubishi 700 Series Instruction Manual

3.2.4

Operation lock (Press [MODE] for a while (2s))

Operation using the setting dial and key of the operation panel can be made invalid to prevent parameter change, and
unexpected start or frequency setting.
Set "10 or 11" in Pr. 161, then press
When the setting dial and key operation is invalid,
operation is invalid,
operation is not performed for 2s, the monitor display appears.)
To make the setting dial and key operation valid again, press
POINT
Set "10 or 11" (key lock valid) in Pr. 161 Frequency setting/key lock operation selection.
Operation
1.
Screen at powering ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Press to read the currently set value.
" " (initial value) appears.
6.
Turn to change it to the set value "
7.
Press to set.
8.
Change
of " " in the similar manner.
(Refer to step 4 to 7.)
9.
Press for 2s to show the key lock mode.
Note
Release the operation lock to release the PU stop by key operation.
for 2s to make the setting dial and key operation invalid.
appears if the setting dial or key operation is performed. (When the setting dial or key
(Pr. 160) appears.
".
(Pr. 161) to the setting value
Press for 2s.
Functions valid even in the
operation lock status
Stop and reset with
appears on the operation panel. When the setting dial and key
for 2s.
Display
PU indication is lit.
PRM indication is lit.
(The parameter number read previously
appears.)
Flicker ··· Parameter setting complete!!
Flicker ··· Parameter setting complete!!
.
Operation panel
35
3