Operation Mode Selection - Mitsubishi FREQROL-U100 Instruction Manual

• Operation mode selection
lZID
The inverter operation modes include operation with external signals and
operation with key pad. Operation can be limited to one mode or can be
carried out with both modes.
Setting value 1 Operation only with key pad
Setting value 2
Operation only with external signals
Setting value 3
Operation trecuencv-: Set with key pad (direct setting or
~l!J
keys)
Start signal", External signal input (STF. STR terminals)
Setting value 4
Operation frequency"" External signal input (DCO to 5V between termtnalsz-s)
Start signal'" Input with key pad (RUN key) (Note) 4.
[Factory setting) 1
(Note)
1. This parameter cannot be rewritten during operation. Er2 will display if writing is attempted.
2. Setting values 3 and 4 are set to use the external signals and key pad operation for the
operation frequency setting and start signals.
3. When set to 3, the operating frequency is set via key pad and analog signa! input is ignored.
4. When set to 4, the operating frequency is set via analog signal input.
-35-