Taking Pictures Using Burst Mode - Panasonic LUMIX DC-G95 Owner's Manual

5. 4K Photo and Drive Settings

Taking Pictures using Burst Mode

Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
1
Set the drive mode dial to [
2
Select the Burst Mode setting.
>
MENU
Settings: [H] (High speed), [M] (Middle speed), [L]
(Low speed)
3
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst Mode.
Burst Rate
∫
[H] (High speed)
[M] (Middle speed)
[L] (Low speed)
Number of burst picture frames
∫
[H] (High speed)
[M] (Middle speed)
[L] (Low speed)
• When recording is performed under the test conditions specified by Panasonic.
The burst speed will become slower halfway. However, pictures can be taken until the capacity
of the card becomes full.
Depending on recording conditions, the number of burst pictures that can be taken will be
reduced.
[Rec] > [Burst Rate]
Burst Rate
9 frames/second ([AFS]/[MF])
6 frames/second ([AFF]/[AFC])
6 frames/second
2 frames/second
With RAW files
30 frames or more
].
Live View during Burst Mode
119
4:3
AFS AFS
L
None ([AFS]/[MF])
Available ([AFF]/[AFC])
Available
Available
Without RAW files
600 frames or more
H