Table of Contents
Advertisement
12. Others
Cleaning
Before cleaning the camera, remove the battery or the DC Coupler (optional) and the
card (optional), and disconnect the power plug from the electrical outlet. Then wipe
the camera with a dry, soft cloth.
• When the camera is soiled badly, it can be cleaned by wiping the dirt off with a wrung wet cloth,
and then with a dry cloth.
• Do not use solvents such as benzine, thinner, alcohol, kitchen detergents, etc., to clean the
camera, since it may deteriorate the external case or the coating may peel off.
• When using a chemical cloth, be sure to follow the accompanying instructions.
About dirt on the image sensor
∫
If dirt gets inside the mount when changing lenses, depending on the recording conditions,
it may adhere to the image sensor and appear on the recorded picture.
To prevent debris or dust adhering to internal parts of the body, avoid changing the lens in
a dusty environment and always fit the body cap or a lens when storing the camera.
Remove any dirt on the body cap before attaching it.
Dust reduction function
The camera has a dust reduction function that will blow off the dirt and dust that have
affixed to the front of the image sensor.
This function will function automatically when the camera is turned on, but if the dirt is
particularly noticeable, from the [Setup] menu, perform [Sensor Cleaning].
Removing dirt on the image sensor
The image sensor is very precise and delicate, so be sure to observe the following when
you do have to clean it yourself.
• Blow dust off the surface of the image sensor using a commercially available blower.
Do not blow the dust off with excessive power.
• Do not put the blower brush further inside than the lens mount.
• Do not let the blower brush touch the image sensor as the image sensor may get scratched.
• Do not use any objects except a blower brush to clean the image sensor.
• If you cannot remove the dirt or dust with the blower, consult the dealer or Panasonic.
Cleaning the Viewfinder
∫
When the viewfinder becomes dirty, blow dirt off the surface of the viewfinder using a
commercially available blower, then lightly wipe with a dry cloth.
• The eye cup is a built-in component, so be careful not to remove it.
• If you wipe the eye cup too hard and it is removed, consult the dealer or Panasonic.
338
Advertisement
Table of Contents
