Table of Contents
Advertisement
Verifier Settings
Verifier
Setting
Verification Type
Passing Grade
Aperture
Max Consecutive
Failures
Verifier Failure
Action
Save Failed
Label Images
Void Pattern
PX940 User Guide
Description
Select the verification type to check the barcode.
None - No barcode validation
Read/No Read - Validate if barcode is readable
ISO15415/15416 - Full ANSI grading of barcode
Sets the minimum passing grade for barcode grading.
Grade 0.0 (F) is the lowest grade.
Grade 1.5 (C) is the default and recommended by ISO
standard. Only applied when verification type is set to
ISO15415/15416.
Indicates the aperture size (in mils) used for verification.
Aperture size will be chosen automatically based on ISO
standard. Change only if required by an overriding
application.
Sets maximum number of times printer encountered
verification failure consecutively before prompting for user
action. This setting is only applicable when the Verification
Failure Action is set to Void and Reprint.
Indicates action to take when label fails verification.
Void and Reprint (default) - Retract and void the failed
label, then reprint the failed label. Stop reprint if the
maximum consecutive failures have been reached.
Ignore and Continue - No voiding when verification fails.
Result is saved and next label is printed.
Note: During multiple label printing, printer will void the
failed label (plus all printed and yet to be verified labels) in
order to keep the good labels in sequence.
When enabled, the printer saves all failed label images in
non-volatile memory. Maximum 100 images can be saved
(if memory available). At maximum capacity oldest image
file will be replaced by newest.
Select the void pattern type to mark the failed label.
Default
ISO15415/
15416
1.5 (C)
Automatic
3
Void and
Reprint
Enable
Diamond
93
Advertisement
Table of Contents
