Installation Instructions; General Installation Notes; Installation And Wiring - Epsolar ViewStar Series User Manual

2. Installation Instructions

2.1 General Installation Notes

 Read through the entire installation section first before beginning installation.
 Be very careful when working with batteries. Wear eye protection. Have fresh water available to wash and
clean any contact with battery acid.
 Uses insulated tools and avoid placing metal objects near the batteries.
 Explosive battery gasses may be present during charging. So well ventilation of battery box is
recommended.
 Avoid direct sunlight and do not install in locations where water can enter the controller.
 Loose power connections and/or corroded wires may result in resistive connections that melt wire
insulation, burn surrounding materials, or even cause fire. Ensure tight connections and use cable clamps
to secure cables and prevent them from swaying in mobile applications.
 Gel, Sealed or Flooded batteries are recommended, other kinds please refer to the battery manufacturer.
 Battery connection may be wired to one battery or a bank of batteries. The following instructions refer to a
singular battery, but it is implied that the battery connection can be made to either one battery or a group
of batteries in a battery bank.
 Select the system cables according to 3.5A/mm

2.2 Installation and Wiring

WARNING: Risk of explosion! Never install the controller in a sealed enclose with
flooded batteries! Do not install in a confined area where battery gassed can
accumulate.
CAUTION: The ViewStar controller requires at least 150mm of clearance above and
below for proper air flow. Ventilation is highly recommended if mounted in an
enclosure.
Installation Procedure:
2
current density.
Figure 2-1 Mounting
3