Installation Preparations - Panasonic Attune WX-C3010 Installation Instructions Manual

5.3 Installation Preparations

1. Before installation confirm the following:
(A) Unpack the equipment and check for any damage. Make sure all equipment needed to complete the installation is on
site. Record all serial numbers.
(B) Make sure that Loop Coil cable is installed, or sonar detector in useable location is used. There must be a continuous
dry contract closure when the vehicle is at the speaker post.
(C) Confirm a clear conduit path into the building dedicated for Center Module cables.
(D) The Center Module is set up from the two AC outlets within 6ft.
2. Start charging batteries so they are useable for system testing.
Note: Because of the many variations in store design, consult with the construction engineer and store for
proper locations of all equipment and conduits.
3. Confirm the Center Module location and securely mount it to the wall.
(A) The clearance to the tip of Center Module and the ceiling is necessary by at least 5 inches.
(B) The area is not surrounded by thick wall or shielded by reflective metals.
Ceiling
5 inch
10 inch
VEHICLE
MARSH
Signal
DETECTOR
Fault
Power
917-1S
Center Module
WX-C3010
AC Outlet
Within 6ft.